대화페인트



HOME 대화페인트
DAEHWA PAINT

대화페인트

제품 목록

ALFROM COAT(Forced Drying)

  • Topcoat for Aluminum and Steel formworks

Product Details

Product Description

Alform coat (Forced Drying) is Acrylic Resin Based, Clear coating that is Designed for use on Aluminum and Steel formwork to protect against corrosion

Recommended Uses

- Topcoat for Aluminum and Steel formworks

Features

- Designed for Forced Drying

- Good Gloss Retention and Alkali Resistance

- Wide range Application

- Excellent Adhesion Aluminum and Steel

Physical properties

Drying time (20μm)

set to touch

Dry Hard

Remark

Air Drying (25)

10 mins

2 hours

Drying times are Temperature,

humidity and Film thickness dependant

Environment Temperature

Drying at 90 ~ 100for 5 ~ 8 minutes

Theoretical coverage (DFT 20μm)

Volume solids (%)

16

Theoretical coverage (/L)

8.0

Drying time (20μm)

set to touch

Dry Hard

Remark

Air Drying (25)

10 mins

2 hours

Drying times are Temperature,

humidity and Film thickness dependant

Environment Temperature

Drying at 90 ~ 100for 5 ~ 8 minutes

Theoretical coverage (DFT 20μm)

Volume solids (%)

16

Theoretical coverage (/L)

8.0

Application procedures

- Surface preparation : Remove dust, oil, grease, moisture and any other contaminant

- Application condition : surface temperature must be at least 3above dew point to prevent condensation and relative humidity must be below 85%

- Application Equipment : Brush, Spray, Roller, Curtain Coater

- Thinner : Not Required

Application information

- Do not apply above 85% R.H. and below 5.

- Optimum application Temperature is suitable for 5 ~ 40 and surface Temperature must be at least 3above dew point to prevent condensation.

- Do not mix with other paint.

- Remove dust, oil, grease and any other contaminant.

- Stir thoroughly before using.

- Use the recommended thinner.

- Apply the Recommended coverage to achieve optimum performance and do not apply above the Recommended coverage per coat.

- Wear suitable protective Equipment During Application.

- The moisture contents in substrate should not exceed 6%(by wt).

- Do not contact moisture water snow and dew.

- Use the mixed paint within pot life.

- If the surface is new concrete, the surface should be cared more than 30 days (PH 7~9)

- If the surface is old paint, confirm compatibility with old paint

- If you want to apply 2~3 coats, Keep the flash off time


Product Notes

Precautions

- Read the Material Safety Data Sheet.

- Avoid contact with eyes.

- Keep out of reach of children.

- Use only in well ventilated areas.

- Do not intentionally breathe vapour.

- Keep away from flames or sparks.

- If in contact with eyes, rinse thoroughly with clean water.