Product Overview

This paint is based on a waterbone, acrylic emulsion polymer. This fast drying paint has excellent properties such as weatherability, abrasion resistance and washability. This paint is environmentally friendly one-component type paint, because of low VOC (volatile organic compounds) content.

2. Product Characteristics

- Fast drying and excellent workability.

- Excellent weatherability and abrasion resistance.

- High durability because it can be coated thick even with one time coating with high solid content.

- Non-flammable, non-toxic (no lead, chromium, mercury, cadmium, etc.) and eco-friendly.

3. Recommended use

- Line marking of asphalt and concrete road

- Line marking for requires retroreflective performance

4. Type (color and grade)

※ These grades are experimental results. Quality can not be guaranteed if user does not observe the coating thickness, type of glass and the amount of application.

5. Properties

※ The application area may vary depending on the condition of the road surface and the coating method.

6. Reflective glass beads

7. Painting specification

- Surface preparing : Remove the moisture, dirt, oil etc from the surface of the road.

- Surface condition : To avoid condensation of moisture, the surface temperature should be more than 10 ℃ or more than 3 ℃ higher than dew point, and the relative humidity should be 70% or less.

- Application : spray, roller

- Thinner : non thinning

- Temperature : Use at atmospheric temperature 10 ℃ ~ 40 ℃.

( ※ Application below 10 ℃ will causes poor drying and poor adhesion. )

- Vehicle pass available time : min. 20 / 20 ~ 25℃ (Recommended film thickness wet. 420㎛)

8. Cautions on painting

- Avoid painting when the relative humidity is above 70% and the substrate surface temperature is below 10℃.

( Occur of problem (crack, poor adhesion etc.) )

- Do not mix with other company products.

- Use after confirming the compatibility with the old film on repairing the old film.

- Use the total amount that has been opened products. Storage containers are then sealed and stored at a

temperature 5 ℃ ~ 35 ℃ and humidity of 70% or less.

- It is possible that the film is formed on the product, so please use the filter net when entering the storage tank to

prevent the film from entering.

- Remove the moisture, dirt, oil etc from the surface of the road.

- Stir to be mixed uniformly before application.

- Don′t thinning.

- It is necessary to coat with the specified coating amount. In case of excessive coating at one time, the problem of

drying failure may occur.

- If the coating surface is new concrete, apply it when the curing time is sufficient (curing for more than 30 days at 20 ℃),

the pH is 7 ~ 9 and the water content is less than 8%.

- In case of repetitive painting, it should be painted after confirming that it is sufficiently dried.

(Lifting, wrinkling, reverling, etc. may ocuur)

- Use at atmospheric temperature 10 ℃ ~ 40 ℃. For avoid condensation of moisture, the surface temperature should

be more than 10 ℃ or more than 3 ℃ higher than dew point.